1.1 Primary vs. secondary storage

In traditional parlance, primary storage contains data that are actively being used (for example, the programs currently being run and the data they are operating on). It is typically high-speed, relatively small, is often (but not always) volatile. It is sometimes referred to as "Main Memory."It can be accessed immediately and randomly.

Secondary storage, also known as peripheral storage, is where the computer stores information that is not necessarily in current use. It is typically slower and higher-capacity than primary storage. It is almost always non-volatile.It is slow due to serial access(thus it is also termed Serial Access Memory).

Confusingly, these terms are often used differently. Primary storage can be used to refer to local random-access disk storage, which should properly be called secondary storage. If this type of storage is called primary storage, then the term secondary storage would refer to offline, sequential-access storage like tape media.

1.2 Volatile storage

Volatile storage loses its contents when it loses power; non-volatile storage does not.

1.3 Random vs. sequential access

Random-access media has the property of accessing any portion at any time. Semiconductor memory (RAM) and magnetic disk are examples of this type of storage.

Sequential-access media by contrast must be read in sequence regardless of the desired content. Magnetic tape and certain types of flash memory have this property.

1.4 Mutable vs. immutable storage

Data stored in mutable storage can be overwritten at any time. Data stored in immutable storage cannot be overwritten. Systems can be made more secure by storing programs and static data in immutable storage, where they can't be changed by an attacker. Dynamic data is stored in mutable storage because it must be changed from time to time. Most operating systems store all programs and data on hard disk drives, which are inherently mutable storage devices. File system permissions can be used to make certain areas of the hard disk logically immutable. However, the superuser is normally not affected by these permissions thus allowing some attacks to succeed.

Some operating systems, such as Linux, extend this logical immutability so data remains immutable even if an attacker gains superuser access. Attackers may be able to destroy the data but they can't change it.

1.5 Block vs. file access

In disk storage, these are the two primary access methods. Block access means that the disk is divided into normally equal-sized blocks which are accessed at random by the operating system. File access contains an abstraction of files and directories which can be used to refer to storage content. Another access method, content-addressable storage (CAS) uses a hashing algorithm to refer to pieces of data.

2 A list of storage devices

• Semiconductor Memory:
  • EPROM
  • Flash memory
  • NVRAM
  • RAM
  • ROM
  • VRAM
  • WRAM
• Cache memory
• Core memory aka Ferrite core memory
• Core rope memory
• Delay line memory
• Magnetic Disk:
  • Floppy disk
  • Hard disk
• Magneto Optical
• Optical Media:
  • PD
  • CD-R
  • CD-ROM
  • CD-RW
  • DVD-RAM
  • DVD-ROM
• Magnetic tape
• Holographic memory
• Bubble memory
• Magnetic drum
• Memory stick
• Mylar® tape
• Paper tape
• Punch card
• Selectron tube
• Smartdisk
• Thin film memory
• Williams tube
• Zip drive

3 A list of memory-related software

• Aard
• QEMM

4 See also

• Memory allocation
• Memory protection
• Memory management, memory leak, memory debugger
• Write protection
• Virtual memory
• Physical memory
• Linear memory
• Computer file
• List of file formats
• Wait state
• Disk Storage
• Computer Storage Density

Digital electronics Computer storage Computer terminology Information technology

<Hide>